Step 1: Fix the machine.
Step 2: Assemble the power distribution.
The third step: connect the electricity. The machine is equipped with 3*2.5+2*1.5㎜2 sheathed cable. To connect electricity at the end of the power supply in the workplace, a manual zoning power supply device must be used. The motor system of the machine can be disconnected from the power supply system if necessary. The switch or circuit breaker must be able to load 32A, and the machine and cable ground must be grounded. Electrical wiring should comply with the provisions of GB3836.15-2000 "Electrical Equipment for Explosive Gas Atmosphere Part 15: Electrical Installation in Hazardous Locations (Except Coal Mines)".
Step 4: Install the plastic pipe for the solvent outlet. Comes with a plastic tube and put it in the recycling bin of the machine. Put the plastic tube on the solvent outlet and tighten the fixing collar.
